National Instruments NI VXIpc-882 User Manual
National Instruments Hardware
Table of contents
Document Outline
- NI VXIpcTM-882 User Manual
- Support
- Important Information
- Compliance
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation
- Chapter 3 Configuration and Default Settings
- Hardware Default Settings
- Default Software Settings
- Slot 0 Detection
- VXIbus CLK10 Routing
- Trigger Input Termination
- BIOS Configuration
- System CMOS
- Software Configuration
- Measurement and Automation Explorer (MAX)
- Default MAX Settings
- Table 3-7. VXIpc MAX General Tab Settings
- Table 3-8. VXIpc MAX Device Tab Default Settings
- Table 3-9. VXIpc MAX Shared Memory Tab Default Settings
- Table 3-10. VXIpc MAX VXI Bus Tab Default Settings
- Table 3-11. VXIpc MAX PCI Tab Default Settings
- Table 3-12. VXIpc MAX SMB Tab Default Settings
- VXI-MXI-2 Default Settings
- Table 3-13. VXI-MXI-2 General Tab Default Settings
- Table 3-14. VXI-MXI-2 Device Tab Default Settings
- Table 3-15. VXI-MXI-2 MXI-2 Bus Tab Default Settings
- Table 3-16. VXI-MXI-2 VXI Bus Tab Default Settings
- PCI-MXI-2 Default Settings
- Table 3-17. PCI-MXI-2 General Tab Default Settings
- Table 3-18. PCI-MXI-2 Device Tab Default Settings
- Table 3-19. PCI-MXI-2 Shared Memory Tab Default Settings
- Table 3-20. PCI-MXI-2 MXI-2 Bus Tab Default Settings
- Table 3-21. PCI-MXI-2 PCI Tab Default Settings
- Front Panel SMB ExtClk Setup
- Front Panel SMB TRGIN/TRGOUT
- Measurement and Automation Explorer (MAX)
- Chapter 4 Developing Your Application
- Chapter 5 I/O Information
- Chapter 6 Common Questions and Troubleshooting
- Appendix A Specifications
- Appendix B Using The Trigger Ports On The NI VXIpc-882
- Appendix C VMEbus Capability Codes
- Appendix D Technical Support and Professional Services
- Glossary
- Index