National Instruments NI VXIpc-882 - Manual (Page 19)

Chapter 2 Installation
© National Instruments Corporation 2-5 NI VXIpc-882 User Manual
2. Remove the component side cover. Refer to the removal instructions in
the
Removing the NI VXIpc-882 Component Side Cover section.
3. Add the SO-DIMM modules to the empty SO-DIMM sockets. Refer to
Figure 2-2.
Note To optimize both memory capacity and system performance, use the same size and
speed memory module in each of the two module slots. The use of different size modules
in each slot is supported, but system performance will be slower than using two matched
modules. However, two mismatched modules will result in better performance than using
a single module.
Figure 2-2. Installing a SO-DIMM in an NI VXIpc-882 Controller
1 SO-DIMM Socket XA1 2 SO-DIMM Module 3 SO-DIMM Socket XA2
3
2
1