What’s in the box, E-iv, Important information – NEC LT180 User Manual
Page 5: Lamp replacement, Lens cap, Lamp status power on/stand by au to ad j
E-iv
Lamp Replacement
•
To replace the lamp, follow all instructions provided on page
•
Be sure to replace the lamp when the message "The lamp has reached the end of its usable life. Please
replace the lamp." appears. If you continue to use the lamp after the lamp has reached the end of its usable
life, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do not touch them as
the pieces of glass may cause injury.
If this happens, contact your dealer for lamp replacement.
•
Allow a minimum of 60 seconds to elapse after turning off the projector. Then turn off the main power switch,
disconnect the power cable and allow 60 minutes to cool the projector before replacing the lamp.
What’s in the Box?
Make sure your box contains everything listed. If any pieces are missing, contact your dealer.
Please save the original box and packing materials if you ever need to ship your Projector.
IMPORTANT INFORMATION
Lens cap
CO
NT
RO
L
CO
MP
ONE
NT IN
CO
MP
UTER
IN
MON
ITO
R OU
T
VIDEO
IN
AU
DIO
IN
S-V
IDE
O I
N
R
Cr/Pr
Cb/Pb
Y
L/m
ono
AUD
IO IN
SE
LE
CT
LAMP
STATUS
POWER
ON/STAND BY
AU
TO
AD
J.
AC
IN
Projector
Remote control (7N900601)
Batteries (AAA
ן
2)
Power cable
(US: 7N080213)
(EU: 7N080007)
RGB/VGA signal cable
(7N520032)
1
2
Quick
Setup
Guide
Important
Information
For North America only
Registration card
Limited warranty
For Europe only
Guarantee policy
Band (use for bundling cables)
(24B17871)
Soft case
(24BS7471)
Shoulder belt
Quick Setup Guide
Important Information
CD-ROM
User’s manual