NEC LT180 - Manual (Page 26)

E-19
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable's two-pin plug to the AC IN of the projector, and then connect the other
plug of the supplied power cable in the wall outlet.
2. INSTALLATION AND CONNECTIONS
CONTROL
COMPONENT IN
COMPUTER IN
VIDEO IN
AUDIO IN
S-VIDEO IN
R
Cr/Pr
Cb/Pb
Y
L/mono
AUDIO IN
MONITOR OUT
S
LA MP STA TU S PO WER
ON /ST AND BY
AU TO AD J.
AC IN
CAUTION
Do not unplug the power cable from the wall outlet under any one of the following circumstances.
Doing so can cause damage to the projector:
* While the projector is turned on.
* While the cooling fans are running. (The cooling fans continue to work for 60 seconds after the projector
is turned off).