Nokia 2355 - Manual (Page 62)

Copyright © 2006 Nokia. All rights reserved.
S e t t i n g s
52
The activated feature code is now
stored in your device, and you are
returned to the Feature code: field.
Continue entering other feature
codes, or press the end key to
return to standby mode. When you
enter a network feature code
successfully, the feature becomes
visible in the Network services
menu.
Call divert
Call divert tells your network to
redirect incoming calls to another
number. Call divert is a network service
and may not work the same in all
networks, so contact your wireless
service provider or network operator
for availability.
Activate
The following options may not all
appear in the display. Contact your
wireless service provider or network
operator for more information.
1. In standby mode, select Menu >
Settings > Network services > Call
divert and one of the following
options:
Divert all calls —Divert all calls to
the number you specify.
Divert if busy —Divert incoming
calls when you are in a call.
Divert if not answered —Divert
incoming calls to another number
if you are unable to answer. You
can set a delay before diverting
takes place.
Divert if out of reach —Divert
incoming calls when your device is
off.
2. Select Activate .
3. Enter the number to which to
divert your calls, and select OK .
Cancel
In standby mode, select Menu >
Settings > Network services > Call
divert > Cancel all call divert . Cancel
all call divert may affect your ability to
receive voice mail messages. Contact
your wireless service provider or
network operator for specific details.
Call waiting
If your wireless service provider or
network operator supports this feature,
call waiting notifies you of an
incoming call even while you are in a
call. You can then accept, reject, or
ignore the incoming call.
1. In standby mode, select Menu >
Settings > Network services > Call
waiting > Activate or Cancel .
2. During a call, select Answer , or
press the call key or voice key to
answer the waiting call. The first
call is put on hold.
3. Press the end key to end the active
call.