National Instruments E Series User Manual

Page 127

Index



National Instruments Corporation

I -5

DAQCard E Series User Manual

differential connections

DIFF input configuration, 4-14
floating signal sources, 4-16 to 4-17
ground-referenced signal

sources, 4-15

nonreferenced signal sources,

4-16 to 4-17

recommended configuration

(figure), 4-13

single-ended connections, 4-18 to 4-20

floating signal sources (RSE

configuration), 4-19

grounded signal sources (NRSE

configuration), 4-19 to 4-20

input polarity and range, 3-3 to 3-5

DAQCard-AI-16E-4

actual range and measurement

precision (table), 3-4

unipolar and bipolar, 3-3 to 3-4

DAQCard-AI-16XE-50

actual range and measurement

precision (table), 3-5

unipolar and bipolar, 3-3 to 3-5

dither, 3-6 to 3-7
mixing bipolar and unipolar channels

(note), 3-5

selection considerations, 3-6 to 3-7

installation

hardware, 2-1
questions about, D-2
software, 2-2 to 2-3
typical configuration (figure), 2-2
unpacking DAQCard E Series, 1-6

I/O connectors, 4-1 to 4-9

cable connectors for DAQCard E Series,

1-6

exceeding maximum ratings

(warning), 4-1

I/O signal summary (table)

DAQCard-AI-16E-4, 4-5 to 4-7
DAQCard-AI-16XE-50, 4-8 to 4-9

pin assignments (figure)

50-pin AI connector, B-3
68-pin AI connector, B-2
DAQCard-AI-16E-4 and

DAQCard-AI-16XE-50
(figure), 4-2

signal descriptions (table), 4-3 to 4-5

LabVIEW and LabWindows/CVI application

software, 1-2 to 1-3

manual.

See documentation

memory conflict, C-2, C-4
multichannel scanning, 3-7 to 3-8

NI-DAQ driver software, 1-3 to 1-4

power-down utility, A-12

noise, avoiding, 4-44
NRSE (nonreferenced single-ended input)

description (table), 3-3
differential connections, 4-16 to 4-17
recommended configuration

(figure), 4-13

single-ended connections (NRSE

configuration), 4-19 to 4-20

optional equipment, 1-5 to 1-6

PC (PCMCIA) Card questions and answers,

C-1 to C-4

configuration, C-1
operation, C-2
resource conflicts, C-4
resources, C-2 to C-4