NETGEAR DG834GUV5 User Manual
Page 75

DG834GUv5 Wireless Router with Built-in DSL Modem User Manual
Advanced Configuration
5-5
v1.0, May 2009
2. Change the settings. For more information, see
,
“Defining Reserved IP Addresses” on page 5-7
3. Click Apply to save the changes.
The LAN TCP/IP Setup parameters are explained in the following table.
Table 5-2. LAN IP Setup
Settings
Description
LAN TCP/IP
Setup
IP Address
The LAN IP address of the modem router.
IP Subnet Mask
The LAN subnet mask of the modem router. Combined with
the IP address, the IP Subnet Mask allows a device to know
which other addresses are local to it, and which must be
reached through a gateway or modem router.
RIP Direction
RIP (Router Information Protocol) allows a modem router to
exchange routing information with other routers. This
setting controls how the modem router sends and receives
RIP packets. Both is the default.
• Both or Out Only. The modem router broadcasts its
routing table periodically.
• Both or In Only. The modem router incorporates the RIP
information that it receives.
• None. The modem router will not send any RIP packets
and will ignore any RIP packets received.
RIP Version
This controls the format and the broadcasting method of the
RIP packets that the modem router sends. It recognizes
both formats when receiving. By default, this is RIP-1.
• RIP-1 is universally supported. It is adequate for most
networks, unless you have an unusual network setup.
• RIP-2 carries more information. Both RIP-2B and RIP-2M
send the routing data in RIP-2 format. RIP-2B uses
subnet broadcasting. RIP-2M uses multicasting.
DHCP Server
For more
information, see
“Using the
Modem Router
as a DHCP
Server” on
page 5-6
.
Use Router as a DHCP
Server
This check box is usually selected so that the modem router
functions as a Dynamic Host Configuration Protocol
(DHCP) server. See
“Using the Modem Router as a DHCP
Starting IP Address
Specify the start of the range for the pool of IP addresses in
the same subnet as the modem router.
Ending IP Address
Specify the end of the range for the pool of IP addresses in
the same subnet as the modem router.