NetComm SmartVoice Gateway - Manual (Page 43)

SmartVoice Gateway(s) User Guide 43
YML832 Rev1
Digit Map
There are 50 sets of leading digit entries to choose voice routing interface – Auto select, PSTN or VoIP.
• Default Call Route: The default call route can be Auto, VoIP, PSTN and Deny.
Auto (VoIP first): The call route is VoIP first, and the next is PSTN.
VoIP: The call route is VoIP only.
PSTN: The call route is PSTN only.
Deny: The call will be deny if the dial-out number is not in the table.
• Enable: Enable detection of this entry.
• Leading Digits: The leading digits for the VoIP gateway to scan while the user is dialing.
• Total Digit Count: Total number of digits that VoIP gateway should accept. 0 means that the VoIP
gateway scans leading digits only and disregards total digit count.
• Route: The interface that calls should go through if above conditions are satisfied.
Example:
For the above setting, if a user dialed 0394978867, which matches Digit Map rule 1, then the gateway
will route this call through VoIP. If 0294278766 is dialed, then the gateway will route this call through
PSTN.