NetComm SmartVoice Gateway - Manual (Page 27)

SmartVoice Gateway(s) User Guide 27
YML832 Rev1
Telephony Settings
Prefix Number Rules
• Trunk Dial Out Verify/ Trunk Dial Out Replace: The system will transfer the number for all transit
out calls through the FXO port. For example: If you transit out with 01907123456, the system will
replace it with 190601 907123456. If you transit out with 008621123456 the system will replace it
with 190200 8621123456.
• Trunk Dial Out Deny: The system will deny the call with the leading number filled in this column.
NOTE: This rule only applies to transit out calls of gateway FXO ports.
• FXS Caller ID Generation: Select this option to enable the caller ID display function on FXS ports.
FSK is used for Australian caller ID standards.
• FXO Caller ID Detection: Used to detect the Caller ID delivered from the PSTN to the FXO port.
When enabled, the Caller ID detected on the FXO port will be sent to the SIP Proxy Server on transit
in (dialing out) calls.
• Detection
Level: If FXO can’t detect Caller ID, try to adjust it until it can.
NOTE: You have to enable “Wait for Caller ID before FXO / Trunk pick up” to ensure
Caller ID is detected correctly.
• FSK Caller ID Type: Bellcore is used in Australia caller ID standards.
• Anonymous Caller ID (CLIR): When enabled, the gateway will use “anonymous” as caller
identification to place calls.
• Anonymous Transit in W/O Caller ID: When enabled, if the FXO can detect caller ID in calls
from PSTN, the gateway will use the detected caller ID as caller identification for transit in calls; if
FXO cannot detect caller ID, the gateway will use “anonymous” as caller identification for transit in
calls. When it not checked, if the FXO can detect caller ID in calls from PSTN, the gateway will use
the detected caller ID as caller identification for transit in calls; if FXO cannot detect caller ID, the
gateway will use its port phone number as caller identification for transit in calls.
• Trunk Incoming Prompt Voice: Select the greeting (must use the IVR 132 function to record a
voice file) when FXO receives an inbound call (transit in).
• FXO Hunting VoIP call in option:
Caller Indicate Dial-Out: When users make calls to FXO ports from Internet, they will be required to
dial a PSTN number after the calls connects to FXO port.
Default Dial-Out: When users make calls to FXO ports from Internet, the gateway will dial to PSTN
with the number filled in “FXO Hunting Default Dial-Out”.