NetComm SmartVoice Gateway - Manual (Page 12)

12 SmartVoice Gateway(s) User Guide
YML832 Rev1
Network Connections
Possible network connections are divided into 3 basic modes as described below:
• Gateway can be assigned with a Public IP Address
• Gateway can be installed under the existing NAT
• Gateway can be assigned with a Public IP address and serve as an IP sharing router.
Gateway Assigned with a Public IP Address
The VoIP gateway will have a Public IP address for its Internet connection regardless of whether it is a
static IP address, DHCP (using a Cable Modem), or PPPoE (Dialup / ADSL).
The following diagram shows a typical network connection in which broadband devices, such as an ADSL
router or Cable modem, need to work in bridged mode so that the gateway is able to obtain a public IP
address either through PPPoE, DHCP or static IP.
Gateway IP Settings Need to be set up as static IP, DHCP, or PPPoE
NAT/STUN Settings Unnecessary (Disabled)
DDNS Settings Unnecessary (Disabled)
Note: The above diagram shows a 4-port SmartVoice gateway for illustration purposes.
An 8, 16 or 32 port SmartVoice gateway could also be used depending upon your
network requirements.