Rear panel (all models), Restore the gateway – NetComm SmartVoice Gateway User Manual

Page 10

SmartVoice Gateway(s) User Guide

YML832 Rev1

Rear Panel (all models)

Phone ports are telephone ports (FXS) to be connected to telephone sets or PBX CO ports. Line ports
(FXO) are to be connected to PSTN lines (telephone lines from a PSTN network).

NOTE: Do not connect FXS ports to each other. Also, do not connect any FXS port
directly to a PSTN line or internal PBX. Doing so may damage VoIP gateway.

Restore the Gateway

To restore the gateway to its factory default setings (IP address, Username and Password only):

(1) Disconnect the power plug.

(2) Press reset (do not let go of the reset button).

(3) Connect the power plug back into the socket (do not let go of the reset button).

(4) Let go of the reset button after 6 seconds. The default IP address and username/password for web

NOTE: This reset action only resets the gateway IP and username/password
settings. Other settings still remain in the gateway’s ﬂash memory. A complete
hardware reset can be done through the gateway’s IVR system and Web
conﬁguration interface.