Nokia 232N - Manual (Page 52)

48
Note that when the keypress tones are switched off,
the DTMF tones are still sent, even though they cannot
be heard.
To join two memory locations, in order to send a
long DTMF string:
³
Recall the phone number to the display (the loca-
tion in which this is stored is called the ‘first’
location, in these instructions).
·
Press * * . The ‘+’ character will be displayed,
after the phone number.
»
Enter the number (one or two digits) of a ‘second’
memory location which is to be linked to that
already selected. Store the new contents in the
‘first’ location.
¿
Press **** to enter a ‘w’ character followed by
the DTMF string and store in the ‘second’ memory
location.
To make a call using the two joined locations:
³
Recall the ‘first’ location, and press SEND . This
dials the phone number, but the dialing sequence
stops on reaching the ‘+’ character.
·
When the call is established, press SEND . This will
cause the phone to send automatically the DTMF
sequence in the ‘second’ location.
NOTE: ‘+’, ‘p’ and ‘w’ cannot be keyed while in a call;
pressing * will send a DTMF tone only.
SID Screen (Menu 18) – Only available in models
where this feature is available
System Identity (SID) information can be programmed
into the phone by your dealer (the identities of specific
networks on which the phone will operate can be
programmed into each NAM).
NOTE: This menu will appear only if SID information
has been programmed into the selected NAM (use
Menu 7 to select a NAM).
You may set the ‘SID Screen’ function to on or off
(SID SCRN ON/OFF) . Depending on (1) the pro-
grammed information, (2) the system selected
(using Menu 1), and (3) the actual availability of
networks in your area, setting SID to on or off will
provide the following conditions: