Nokia 232N - Manual (Page 51)

To place a pause between DTMF digits (when
entering the number):
Press * * * . The ‘p’ character will be displayed.
When the DTMF number is sent, a pause of 2.5
seconds will be inserted automatically.
To place a ‘wait’ character (when adding a DTMF
string to a phone number, or requiring a ‘wait’
within a DTMF string):
It is necessary to place a ‘wait’ character (‘w’) between
a phone number and the subsequent DTMF string.
In addition, you may include a ‘w’ character at any
point in a DTMF string, if required.
On reaching each ‘w’ character, the phone ‘waits’ for
you to press
SEND . On pressing SEND , the phone will
automatically send as DTMF all the numbers or digits
following the ‘w’ (until the next ‘w’, if any, is reached).
You can also press
MENU SEND or MENU 17 at this
point to send DTMF.
To enter a wait character (to precede a DTMF string,
or within the string):
³
Recall the phone number, or enter the number, as
appropriate.
·
Press * * * * . The ‘w’ (wait) character will be
displayed, after the phone number.
»
Enter the DTMF number (i.e. after the ‘w’
character).
¿
To enter a ‘w’ character within the DTMF number,
press
* * * * .
´
Store the whole sequence in a memory location.
To send DTMF numbers:
³
Recall the phone number from memory using the
RCL key.
·
Make the call in the usual way (i.e. press SEND ).
»
When the call has been answered, press SEND
again to send the DTMF number.
¿
If any further wait character is encountered, within
the DTMF string, press
SEND again to send the
remaining part of the DTMF string.
´
To stop DTMF sending, press CLR .
47