Nokia 232N - Manual (Page 27)

If storing was successful, the message STORED will
be displayed, confirming that the information has been
stored in the location number shown on the display.
However:
– If the location is already occupied when storing a
new entry, REPLACE CONTENT? is displayed.
– If the location is empty but the name being stored
exists in another location, then MOVE NAME?
will be displayed. Confirmation of this causes the
location containing the name previously stored to be
erased when the new name is stored.
In any of these instances, either:
– Press STO (within 8 seconds) if you want to replace
the existing information, or
– Press CLR or wait until the message STORE NOT
DONE appears if you do not want to delete the
existing information.
The information you tried to store will then re-appear
on the display, and you can then store it in another
location.
There are some situations where the store cannot be
done. In such an instance, a message is displayed:
– If there is no room to store a new entry, MEMORY
FULL is displayed.
– If the location chosen is full, and the name being
stored already exists in another location then
LOCATION FULL is displayed. Either wait for the
information you tried to store to re-appear, or press
CLR , then store the information in another location.
– If the name entered is too long to be stored, then
NAME TOO LONG is displayed and the name is trun-
cated. Press STO again to store the truncated name.
– If there is no room at all for the name, then
NO ROOM FOR NAME is displayed and the name
is deleted. Press STO again to store only the number.
Alternative quick method for storing to the ‘one-touch
dialing’ locations 96, 97 (
* and # keys respectively)
and location 98 (voicemail/favorite number ):
³
Enter the number/name.
23