Nortel Networks NN44200-313 - Manual (Page 20)

20 CallPilot resource configuration
Prompt Response Notes
CSQI xxx Enter the number of CallPilot
DS0 channels multiplied by 2.
For example, if there are 24
DS0 channels, enter 48.
CSQO xxx Enter the number of CallPilot
DS0 channels multiplied by 2.
For example, if there are 24
DS0 channels, enter 48.
4 To exit the overlay, enter ****.
—End—
Defining CallPilot in the customer data block (LD 15)
Tech tip: To view current system parameters, go to LD 21 and enter PRT at
the REQ prompt, and then CDB and the appropriate customer number. The
result is a list of all the current information in the Customer Data Block. Use
the capture text function in hyperterminal to save a text file of the output.
Step Action
1 Connect to the PBX.
2 Enter LD 15.
3 Enter the appropriate values as described in the following table to
add Call Park Allowed and Message Center Included. For prompts
not listed in the following table, press Enter to accept the default.
Table 5
LD 15 - Configuring Call Park Allowed and Message Center Included
Prompt Response Notes
REQ CHG
TYPE ftr
CUST xx Customer number for CallPilot.
OPT CPA MCI
IDEF YES
NO
If Call Forward by Call Type
(CFCT) is enabled on the CS
1000 or M1 switch, enter YES.
Otherwise, enter NO.
Nortel CallPilot
Quickstart Guide
NN44200-313 01.02 Standard
5.0 19 May 2008
Copyright © 2007-2008, Nortel Networks
.