NETGEAR CVG824G - Manual (Page 35)

Wireless Cable Voice Gateway Model CVG824G Reference Manual
Wireless Configuration 2-13
v1.0, November 2006
To add a device to the Access List:
1. Add a device to the Access List using either of the following methods:
a. If the computer is in the Connected Wireless Devices table, click the radio button of that
computer to capture its MAC address; or
b. Specify the MAC address of the device to be added to the Access List in the Add Access
Filter fields. The MAC address can usually be found on the bottom of the wireless device.
2. Click Add.
3. Repeat Steps a or b and 3 for each wireless PC that you are adding.
4. Click Apply to save these changes. Now, only devices on this list will be allowed to wirelessly
connect to the gateway.
To delete an entry from the Access List:
Check the corresponding radio button in the Access List and click Delete.
Figure 2-9
Note: If no Device Name appears when you enter the MAC address, you can type a
descriptive name for the computer that you are adding.