Using on-screen menu, 1) using the menus, Using the menus – NEC NP2250 User Manual

Page 94

 Using the Menus

1. Press the MENU button on the remote control or the projector cabinet to display the menu.

NOTE: The commands such as



ENTER, EXIT in the bottom show available buttons for your operation.

2. Press the SELECT

 buttons on the remote control or the projector cabinet to display the submenu.

3. Press the ENTER button on the remote control or the projector cabinet to highlight the top item or the

first tab.

4. Use the SELECT

 buttons on the remote control or the projector cabinet to select the item you want

to adjust or set.

You can use the SELECT

 buttons on the remote control or the projector cabinet to select the tab you

want.

5. Press the ENTER button on the remote control or the projector cabinet to display the submenu window.

6. Adjust the level or turn the selected item on or off by using the SELECT

 buttons on the remote

control or the projector cabinet.

Changes are stored until you adjust it again.

7. Repeat steps 2 -6 to adjust an additional item, or press the EXIT button on the remote control or the pro-

jector cabinet to quit the menu display.

NOTE: When a menu or message is displayed, several lines of information may be lost, depending on the signal or settings.

8. Press the MENU button to close the menu.
To return to the previous menu, press the EXIT button.

6. Using On-Screen Menu