NEC NP2250 - Manual (Page 39)

5
3. Projecting an Image (Basic Operation)
 Selecting a Source
Selecting the computer or video source
Detecting the Signal Automatically
Press and hold the SOURCE button for a minimum of 1 second, the projector
will search for the next available input source. Each time you press and hold the
SOURCE button for a minimum of 1 second, the input source will change as fol-
lows:
COMPUTER1 → COMPUTER2 → COMPUTER3 → COMPONENT → VIDEO
→ S-VIDEO → VIEWER → COMPUTER1 → ...
If no input signal is present, the input will be skipped. When the input source
you wish to project is displayed, release the button.
Using the Remote Control
Press any one of the COMPUTER 1/2/3, COMPONENT, VIDEO, S-VIDEO,
VIEWER or NETWORK buttons.
LASER
OFF
AUTO ADJ.
ON
ASPECT LAMP MODE
R-CLICK L-CLICK
MOUSE
FREEZE
PIP
VOLUME MAGNIFY PAGE
UP
DOWN
SELECT
POWER POWER
MENU
ENT
ER EXI T
VIDEO
S-VIDEO
VIEWER
NETWORK
COMPUTER
COMPONENT
3
1 2
Selecting from Source List
Press and quickly release the SOURCE button on the projector cabinet to dis-
play the Source list. Each time the SOURCE button is pressed, the input source
will change as follows: “COMPUTER 1/2/3”, “COMPONENT”, “VIDEO” (VCR),
“S-VIDEO”, “VIEWER” (slides on a USB memory) or “NETWORK” (LAN port
[RJ-45] or installed USB wireless LAN unit).
To display the selected source, press the ENTER button.
POWER AUTO ADJUST
USB
LAMP
STATUS
ON/STAND BY SOURCE 3D REFORM
SELECT
POWER AUTO ADJUST
USB
LAMP
STATUS
ON/STAND BY SOURCE 3D REFORM
SELECT