Nortel Networks M760 - Manual (Page 88)

Settings
80
Funct.
Feature
Passwd
Enter
Enter
Modify
1 - Press the Funct. interactive key.
The display shows “SELECT A FUNCTION”.
2 - Press the Feature interactive key.
The display shows “SELECT A FEATURE”.
3 - Press the Passwd interactive key.
The display shows the code programming status.
4 - Press the Modify interactive key.
The display will ask you to dial the current code.
5 - Dial the current password .
Note: if not customized, the code will be 0000 by default.
. In the event of error, press the
Erase interactive key.
6 - Press the Enter interactive key.
. In the event of error, press the Modify interactive key then
restart.
The display will ask you to dial your new password.
7 - Dial the new paswword (4 digits) then press the Enter
interactive key.
The display will ask you to confirm this password.
8 - Dial the new paswword a second time then press the Enter
interactive key.
Note: remember this code. You will need it to access certain
functions.
Customizing the set password
Password xxxx
New password xxxx
Enter
New password xxxx
To access certain facilities (unlocking the set, replace function, etc.) you will need a password.
This code (which is different to the mailbox access code) will be 0000 by default. You will
have to customize this password prior to any use (to unlock the set, for example).
With the set idle,
- Consecutively press keys
or to decrease or increase the
key beep volume.
Each time pressed, the new setting is broadcast.
The last setting made remains stored by the set.
Adjusting the key beep volume
Each time a key is pressed, a beep is given. The volume of this beep can be adjusted to 8 lev-
els. The lowest level corresponds to elimination of the beep.