NEC EXPRESS 320Lb User Manual

Page 15

Windows 2000 Advanced Server Installation 2-5

9. At the

Product ID

prompt, enter the product ID using capital letters and

specifying any hyphens.

Press

Enter

to continue.

At the

Are you sure?

prompt, enter

10. At the partition size block, enter the size of the partition (a minimum of

2000 MB or

All

(to make the partition the size of the disc). Size must be

entered in MB. If you enter a size greater than the capacity of the disk, then
it uses the entire disk. Press

Enter

when done.

11. At the

Are you sure?

prompt, enter

to continue.

12. At the prompt, remove the ExpressBuilder CD from the CD-ROM drive and

insert the Windows 2000 CD in the drive.

Wait for the CD-ROM drive to cycle up before pressing

Enter

The system starts copying Windows 2000 to the system drive. This
takes about 15 minutes to complete.

13. If you are using a Windows 2000 CD which does not include Service Pack 3

integrated, at the prompt, remove the Windows 2000 CD from the drive and
insert the Windows 2000 Service Pack 3 CD into the drive; if you are using
a Windows 2000 CD which does include Service Pack 3 integrated,
Windows 2000 setup will begin immediately.

Wait for the CD-ROM drive to cycle up.

Press any key to continue. Leave the Service Pack CD in the drive until
the installation process is completed.

Note:

When the system reboots during the installation,

you are presented the option to boot Windows 2000
Advanced Server or a “previous operating system on C:”
Accept the default of Windows 2000 Advanced Server and
do not select the “previous operating system on C:”

14. Windows 2000 setup begins the process by copying files to the hard disk.

After completing file copying, the system automatically reboots.

Windows 2000 server setup continues, then reboots again.

Windows 2000 server setup automatically converts the file system to
NTFS and reboots.

Windows 2000 setup continues with detecting and installing devices and
components. After installing the devices and components and
performing final tasks, the system reboots.