NEC EXPRESS 320Lb - Manual (Page 14)

2-4 Windows 2000 Advanced Server Installation
Note: If using computers that communicate with the
E XPRESS 5800/ft Series server using TCP/IP protocols, you
must make several settings to the server to minimize
interruptions. See Appendix A, “Setting TCP/IP Protocols”
for information on making the settings.
Installing the Windows 2000 Advanced Server operating
system overwrites the contents of the server’s hard drive. If
you have data you want to keep, copy and store the data on
a network drive, tape drive, or other storage device.
Note: If you are reinstalling Windows 2000 Advanced
Server on a system disk which has been mirrored, if possible
you should first use Disk Management under Computer
Management to break the mirror and revert the disk
mirroring the system disk to a basic disk.
4. Click the Setup icon on the EXPRESSBUILDER Main menu. A Note
displays. Click Confirm .
5. A Notice screen appears asking if you want to overwrite any data currently
on the system drive. Press Enter to continue.
Note: Be sure to leave the EXPRESSBUILDER CD in
the drive until prompted to remove.
The system reboots and starts formatting the installation partition on a hard
drive.
When formatting is completed, the system starts copying server system
software to the system. This takes about ten minutes.
6. After server system software has been copied, you are requested to remove
the EXPRESSBUILDER CD from the CDROM drive AFTER pressing
Enter as the reboot begins. Press Enter and as the system reboot begins,
remove the CD from the CDROM drive.
7. After the system reboots, you are asked whether you wish to use an Ft
update CD. Press No, if you do not have an Ft update CD.
8. You are requested to identify the language version of the Windows 2000
Advanced Server you are installing. Press E for English, F for French, G for
German, I for Italian or press S for Spanish.