Philips Onis 2 - Manual (Page 32)

Connection to a PABX 28
Connection to a PABX
If you use your Oniso on a telephone line connected to a PABX (Private Automatic
Branch Exchange), instead of a direct connection to the public telephone network,
it may be necessary to change certain settings on your telephone.
Selecting the network type
To connect your Oniso to a PABX you may need to change the network setting.
Press
R
, then press + to display 6(783 . Press
o
.
Press
-
until 1(7:25. is displayed, then press
o
.
Use
+
and
-
to choose one of the possible network settings from the
selection available. Press
o
.
Your handset will beep to indicate that the new network type has been set.
Press
R
to leave menu mode.
Depending on your PABX, you may need to try different network settings before
you find the best setting.
Note:
If you want to reconnect your Oniso to the public network again, don’t forget to set
the network type to PUBLIC. The optimum settings for the public network will
automatically be reset.
Setting the recall type
The recall type function defines what signals your telephone sends to the PABX
when the recall
R
key is pressed during a call. You need to select one of the
PABX settings in the 1(7:25. menu before you can choose a recall type.
Press
R
, then press + to display 6(783 . Press
o
.
Press
-
until 5(&$// is displayed, then press
o
.
Press
+
or
-
to select LONG FLASH or SHORT FLSH, then press
o
.
Your handset will beep to indicate that the new recall type has been set.
Press
R
to leave menu mode.
1
2
3
4
1
2
3
4