Philips Onis 2 - Manual (Page 23)

Your Onis Memo recorder 19
Switching on the memo recorder by remote control
Before you can call into your memo recorder by remote control, you need to enter
a remote control code (see “Entering a remote control code” on page 16).
Dial your telephone number. Let it ring 9 times.
The memo recorder will start up and send back a waiting tone.
Press * on the telephone and enter your remote control code.
Press 7 on the telephone keypad and hang up.
Your memo recorder is once again ready to handle calls.
Calling into your memo recorder by remote control
You can call into your memo recorder from any telephone by calling your own
telephone number.
If your memo recorder does not answer, the memory is full or the memo recorder
is not switched on.
Dial your telephone number then, during the outgoing message, press
* on the telephone.
Enter your 4 digit code.
If the code is correct, your memo recorder will play back any messages
automatically.
If the code is wrong, the outgoing message will be repeated. During the
outgoing message, try entering your code again. The memo recorder will
hang up after 3 unsuccessful attempts.
During the call you can enter remote control codes, e.g. 1 to repeat the
current message, 3 to listen to the next message, and so on (see your
Remote Control Memo card for details).
Your Oniso handset allows you to enter all available remote control functions
(except “Erase all messages”). The symbols printed on the keys indicate their
remote control function, e.g. > (key !) to listen to the next message.
Hang up to end the call.
The memo recorder will return to the mode it was in before your call unless
you press 9 to switch off the memo recorder. If it was on, it stays on and is
ready to handle calls.
!
!
"