Philips FW-D596 - Manual (Page 32)

32
English
Setting the PCM output
DIGITAL OUTPUT
PCM 96K
PCM 48K
PCM OUTPUT
NIGHT MODE
CNTR DELAY
REAR DELAY
TEST TONE
PCM 48K OUTPUT
PCM 96K
Select this if the optional audio equipment is
capable of processing digital signal input with
sampling rate of 96 kHz. However, if the sound
output is distorted or there is no sound, select
‘48 kHz’.
PCM 48K
Select this if the optional audio equipment is
incapable of processing 96 kHz digital signal
input, then convert to standard signal with
sampling rate of 48 kHz.
Note:
– The PCM OUTPUT can be selected only when
PCM ONLY is selected.
Night mode - turning on/off
DIGITAL OUTPUT
OFF
ON
PCM OUTPUT
NIGHT MODE
CNTR DELAY
REAR DELAY
TEST TONE
NIGHT MODE SET TO OFF
Off
Select this when you want to enjoy the surround
sound with its full dynamic range.
On
Select this to level out the volume. High volume
output will be softened and low volume output
will be brought upward to an audible level. This
feature is only available for movies with Dolby
Digital mode.
DVD Menu Operations
Test Tone - turning on/off
DIGITAL OUTPUT
AUTO
MANUAL
PCM OUTPUT
NIGHT MODE
CNTR DELAY
REAR DELAY
TEST TONE
SET TEST TONE TO AUTO
AUTO
If you set TEST TONE to AUTO, the system will
start to test speakers from front left, center, and
front right, rear right, rear left and finally the
subwoofer.
MANUAL
Select this item if you want to manual adjust the
speakers level.
– You can hear pink noise from the front left
speaker at first until you press 2 to select center,
front right, rear right, rear left and subwoofer
cyclically.
– Press CENTER +/- to adjust center speaker’s
level you want.
– Press REATR +/- to adjust rear speaker’s level
you want.
– Press SUBW +/- to adjust subwoofer
speaker’s level you want.
You can press 1 to exit at any time during tone
test.
Notes:
– You cannot adjust the level of the front left or
right speaker.
– If no disc is loaded, the TEST TONE function is
still available.
– You can adjust the main volume during tone
test.