Patton electronic Model 3088/I - Manual (Page 20)

Configure the IP address 20
3088/I Getting Started Guide 2 • Initial Configuration
Connect the G.SHDSL port
3. Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.
4. Plug one end of the cable into the (yellow) RJ-11 socket (labelled Line) on the G.SHDSL NTU.
(See figure 6 .)
5. Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.
6. Go to G.SHDSL > Configuration to configure the DSL port parameters.
Note If two G.SHDSL NTUs are connected back-to-back, one must be config-
ured as Remote, the other as Central.
7. The WAN Link LED will flash while in the process of establishing a link. The LED will be on constantly
once a valid DSL connection is established.
Figure 6. Rear view of LB510A showing DSL RJ-11 jack
MDI-X
Line
Ethernet
Power
Console