Planar PD7170 - Manual (Page 87)

Serial Communications
Planar PD7170 Installation/Operation Manual 73
PREL
IMINA
RY
Table 6-2 lists the valid operations commands. For all but Execute functions, the
response from the projector is the command and “= ” where is
the current value or “NA” if the value is not available. For Execute functions the
response is the same command. All responses are in UPPERCASE.
Some operations command examples:
Input: op bright ? [CR]
Response: OP BRIGHT = 100 [CR]
Input: op bright + [CR]
Response: OP BRIGHT = 101 [CR]
Input: op bright = 127 [CR]
Response: OP BRIGHT = 127 [CR]
Input: op bright - [CR]
Response: OP BRIGHT = 126 [CR]
Input: op resync [CR]
Response: OP RESYNC [CR]
Input: op sharp.mode = 1 [CR]
Response: OP SHARP.MODE = 1 [CR]
Input: op sharp.simple = 50 [CR]
Response: OP SHARP.SIMPLE = NA [CR]
Input: op sharp.simple ? [CR]
Response: OP SHARP.SIMPLE = NA [CR]
The last three commands show what happens when a control is grayed out. In
this case, the sharpness mode was set to advanced (value = 1) and then the
simple sharpness slider was attempted to be adjusted and queried. The
response was “NA” or not available.
Table 6-2. Serial Commands
Operation Commands Values Notes
aspect = ? 0 = 16:9
1 = Letterbox
2 = 4:3
3 = 4:3 Narrow
4 = Native
memory = ? 0 = User Memory 1
1 = User Memory 2
2 = ISF Day
3 = ISF Night
4 = Default
? only returns a value if
ISF Day or ISF Night is
active, otherwise it
returns NA
save.mem = 0 = User Memory 1
1 = User Memory 2