Planar PD7170 - Manual (Page 66)

Operation
52 Planar PD7170 Installation/Operation Manual
PREL
IMINA
RY
DynamicBlack: Select DynamicBlack from the Advanced menu to enable (On)
or disable (Off) the DynamicBlack actuator in the optical engine. DynamicBlack
uses a dynamic iris that modulates light to the DMD based on the actual
content of the video material. Planar recommends that you disable
DynamicBlack before adjusting Brightness, Contrast or other image settings.
Adaptive Contrast: Adaptive Contrast enhancement expands the light and
dark portions of an output image according to the mean luminance of the
input image.
RGB Adjust: To remove any trace of color from the white areas of the projected
image, choose RGB Adjust from the Advanced menu and press ENTER. This
displays the RGB Adjust sub-menu, shown in Figure 4-9.
Figure 4-9. RGB Adjust Sub-Menu
• Gain: Use the Gain controls to correct color imbalances in the bright areas of
the image. A good way to do this is to use a test pattern consisting mostly of
solid white areas, such as an 80 IRE “window” pattern. If the white areas
contain traces of red, green or blue, decrease the Gain for that color.
Blue 0.150 0.060 0.155 0.070 0.150 0.060
Magenta 0.321 0.154 0.318 0.162 0.328 0.158
Table 4-3. x/y Color Gamut Values (continued)
Primary
Color
Color Gamut Settings and Associated x/y Values
REC709 SMPTE “C” EBU
x y x y x y