Operations commands, Prel imina ry – Planar PD7170 User Manual
Page 86
![background image](/manuals/188457/86/background.png)
72
Planar PD7170 Installation/Operation Manual
PREL
IMINA
RY
Operations Commands
Operations commands allow more flexible and direct control of the projector.
The syntax for operations commands is as follows:
op
(Precede
The command type can be one of 5 functions:
asp.narr
(none)
0xA1
0xE1
Apply 4:3 Narrow aspect ratio to the
active source.
pip.sw
0xA3
0xE3
Switch to next “PIP Select” state.
pip.1
(none)
0xA4
0xE4
Change “PIP Select” to source 1.
pip.2
(none)
0xA5
0xE5
Change “PIP Select” to source 2.
pip.3
(none)
0xA6
0xE6
Change “PIP Select” to source 3.
pip.4
(none)
0xA7
0xE7
Change “PIP Select” to source 4.
pip.5
(none)
0xA8
0xE8
Change “PIP Select” to source 5.
pip.off
(none)
0xA9
0xE9
Change “PIP Select” to off.
pip.swap
0xAA
0xEA
Swap the PIP image with the active
source image.
pow.tog
(none)
0xAC
0xEC
Toggles between power on and
power off.
lit.tog
0xAD
0xED
Activates remote backlighting only
when pressed momentarily. When
held for five seconds or more, the IR
code for toggling the projector I/O
panel light is transmitted.
Table 6-1. Serial Command Key Names and IR Codes (continued)
RS232
Keyname
Remote Button
IR Code
Description
Set 1
Set 2
PIP
SWAP
LIGHT
➤
Operations Control Commands
Function
Command
Action on unit
Set
=
Makes the unit take that value.
Get
?
Asks what the current value is.
Increment
+
Adds 1 to the current value.
Decrement
-
Subtracts 1 from the current value.
Execute
(none)
Performs an action such as a reset.