Panasonic DMC-F2 User Manual
Page 117
Others
- 11 -
[READ ERROR PLEASE CHECK THE CARD]/
[WRITE ERROR PLEASE CHECK THE CARD]
• It has failed to read or write data.
"
Turn the camera off and remove the card. Insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.
"
Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
• When you set the picture quality to [WVGA] or [VGA], we recommend using a high-
speed card with “10 MB/s” or greater displayed on the package.
• If the operation stops even if you use the card with memory size of 10
MB/s or greater,
this means the data-writing speed has lowered. We recommend backing up the data and
formatting the card. (P
• Depending on the type of SD Memory Card or SDHC Memory Card, motion picture
recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
• A folder cannot be created because there are no remaining folder numbers that can be
used. (P
"
Format the card after saving necessary data on a PC etc. (P
)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera.
"
Press [MENU/SET] if you want to delete this message at once.
"
Select [TV ASPECT] in the [SETUP] menu to change the TV aspect. (P
• This message also appears when the USB connection cable is connected to the camera
only. In this case, connect the other end of the USB connection cable to a PC or a
printer. (P
,
)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
• The printer cannot print.
"
Check the printer.
[NO BATTERY POWER REMAINS]
• The remaining battery power is low.
"
Charge the battery.
[THIS BATTERY CANNOT BE USED]
• The battery cannot be recognized by the camera.
"
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
• The battery cannot be recognized as its terminal is dirty.
"
Remove any dirt etc. from the terminal.