Panasonic DMC-F2 - Manual (Page 116)

Others
- 11 -
[NOT ENOUGH SPACE ON BUILT-IN MEMORY]/[NOT ENOUGH MEMORY ON THE
CARD]
• There is no space left on the built-in memory or the card.
– When you copy pictures from the built-in memory to the card (batch copy), the pictures
are copied until the capacity of the card becomes full.
[SOME PICTURES CANNOT BE COPIED]/[COPY COULD NOT BE COMPLETED]
• The following pictures cannot be copied.
– When a picture with the same name as the picture to be copied exists in the copy
destination. (When copying pictures from the card to the built-in memory)
– Files not based on the DCF standard.
• Moreover, pictures recorded or edited by other equipment may not be copied.
[BUILT-IN MEMORY ERROR FORMAT BUILT-IN MEMORY?]
• This message will be displayed when you format the built-in memory on a PC.
" Format the built-in memory on the camera again. (P 27 ) The data on the built-in
memory will be deleted.
[MEMORY CARD ERROR FORMAT THIS CARD?]
• This card has a format which is not recognized by the camera.
" Format the card again with the camera after saving necessary data on a PC etc. (P 27 )
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR]
• This message appears when the camera is not operating properly.
" Turn the camera off and on. If the message persists, contact the dealer or your
nearest Service Center.
[MEMORY CARD PARAMETER ERROR]/[THIS MEMORY CARD CANNOT BE USED]
" Use a card compatible with this camera. (P 17 )
• You can only use an SDHC Memory Card if using cards with 4 GB or more capacity.
[MEMORY CARD ERROR PLEASE CHECK THE CARD]
• Failed access to the card.
" Insert the card again.
" Insert a different card.