Paradyne Hotwire 6342 - Manual (Page 76)

A. Command Line Interface
A-10 May 2001 6371-A2-GB20-20
Proxy ARP Command
proxy arp { eth1 | dsl1 } [ enable | disable ]
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables Proxy ARP for the specified interface. If enable or disable is not
entered, enable is assumed.
Example: proxy arp dsl1 disable
eth1 – The Ethernet interface.
dsl1 – The DSL interface.
enable – Enable Proxy ARP.
disable – Disable Proxy ARP. The default is disable.
NOTE: Proxy ARP and NAPT cannot be enabled at the same time. When Basic NAT is
enabled, Proxy ARP is allowed on the dsl1 interface.