Paradyne Hotwire 6342 - Manual (Page 101)

C. Traps and MIBs
6371-A2-GB20-20 May 2001 C-3
MIBs Overview
The Hotwire DSL system supports standard as well as Paradyne Enterprise MIBs.
Various configuration, status, and statistical data within the SNMP agent is
accessible from the NMS. The content of an SNMP agent’s MIBs is defined by
various Internet Request for Comments (RFC) documents.
The following sections provide brief descriptions about supported MIBs. Complete,
up-to-date details about the content of all DSL MIBs are available on the Paradyne
Web site at www.paradyne.com. Select Technical Support
→
MIBs.
Standard MIBs
Standard MIBs supported consist of the following:
T RFC 1213: MIB II
T RFC 1573: Evolution of the Interfaces Group
T RFC 2096: IP Forwarding Table MIB
T RFC 2665: Ethernet-Like MIB
MIB II (RFC 1213)
The objects defined by MIB II (RFC 1213) are organized into ten groups:
T System Group – Fully supported. Refer to System Group .
T Interfaces Group – Refer to Interfaces Group (RFC 1573) on page C-5 and
Extension to Interfaces Table (RFC 1573) on page C-7.
T Address Translation Group – Not supported.
T IP Group – Refer to IP Group (RFC 1213) on page C-8 and IP CIDR Route
Group (RFC 2096) on page C-9.
T ICMP Group – Fully supported.
T TCP Group – Fully supported.
T UDP Group – Fully supported.
T EGP Group – Not supported.
T Transmission Group – Refer to Transmission Group on page C-10.
T SNMP Group – Refer to SNMP Group on page C-10.