PSC PT Program Generator - Manual (Page 104)

PT40 Communication
92
PT Program Generator (PPG) v5.0
3. The Falcon PT40 can hold up to four applications. Choose the location
where you want to load your new application.
• Once you select a location, your application is downloaded.
• If there was previously an application in the location you select,
that application will be removed and replaced with a new
application.
Specialized Download Situations
If you are downloading a program file to several portables, or if you switch
between two or more programs in a portable, you can save time by download-
ing the program's compiled file, rather than recompiling the source file each
time.
To do so, launch the PPGXFER directly from Windows via Start > Programs >
PT Program Generator > PPGXFER . Once you're in the PPGXFER window,
use the File > Open command to select your previously compiled *.hex file.
Once you select the file, downloading begins immediately.
Using XFER32
XFER 32 is the application used to send and receive files to and from the
PDT. When you start
XFER32 , the XFER32 user interface, shown in Figure 64 ,
opens.
Figure 64. XFER32 User Interface
XFER32 Setup
To prepare for data transfer between the PC and the PDT, click on the Setup
button to open the Setup dialog box, which contains three tabbed sections:
2342.book Page 92 Thursday, July 22, 2004 8:35 AM