Polycom SpectraLink 1725-36165-001 - Manual (Page 55)

Using the Push-to-talk Features of Your SpectraLink 8030 Wireless Telephone
1725-36165-001-G.doc 55
Use PTT Vibrate
To enhance the alerting of a PTT call, PTT Vibrate may be enabled on
the Config menu.
When PTT Vibrate is enabled, the handset will vibrate three times
whenever a PTT broadcast is received, whether the handset is in
standby or in a call. If in a call, the chirp alert will also sound. The
vibration does not replace any PTT tone volume already set. To set
the handset for PTT vibrate only, enable
PTT Vibrate and set the tone
volume to zero.
PTT Vibrate is disabled by default.
Transmit on the Priority Channel
Press and release the TALK button. Select the priority channel from the
list. Press and hold TALK , then speak. The priority channel takes
priority over all other calls in progress.
End a PTT Call
Press the END key to exit the PTT call.
Change the PTT Volume
Press the up/down volume buttons on the side of the handset while
transmitting or receiving a PTT call.
Answer a Telephone Call during a PTT Transmission
Press the START key. PTT transmissions will be pre-empted by the
telephone call.
Start a Telephone Call during a PTT Transmission
Press the START key and dial the number. PTT transmissions will be
pre-empted by the telephone call.