Printronix SL5000r MP - Manual (Page 28)

Chapter 2 RFID CONTROL Menu
28
Failed Tag Cnt
This menu item displays on the control panel’s LCD the number of
failed tag write attempts since the last Clear Tag Stat operation has
been initiated. (See “Clear Tag Stat” below.)
Tag Void Cnt
This menu item always displays 0 unless the RFID encoder is used
with an attached online data validator. When used with a validator,
Tag Void Cnt represents how many valid RFID tags were
overstruck due to bad bar code scanning. Refer to the
Online Data
Validator User’s Manual.
Tag Read Cnt
This menu item displays the number of tags read since the last
Clear Tag Stat (below).
Clear Tag Stat
This menu item clears the Tag Write Cnt, Failed Tag Cnt, Tag Void
Cnt, and Tag Read Cnt menu items.
F/W-Version
This menu item displays on the control panel’s LCD the reader
firmware version.
Precheck Tags
NOTE: This menu item applies to Class 1 tags only.
When this menu item is set to Enable, the RFID encoder checks the
tags for a pre-programmed quality code. If the code is absent, the
tag immediately fails and the selected Error Handling mode is
performed (Overstrike, None, or Stop). The default is Disable.