Dhcp relay agent commands, A-16 – Paradyne 6371 User Manual
Page 88
A. Command Line Interface
A-16
March
2002
6300-A2-GB20-00
DHCP Relay Agent Commands
Table A-11. DHCP Relay Agent Commands
dhcp relay
{
enable
|
disable
}
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables the DHCP relay agent. The DHCP relay agent will maintain up to
256 DHCP clients.
Example:
dhcp relay enable
enable – Enables the DHCP relay.
disable – Disables the DHCP relay. This is the default setting.
dhcp relay address
ip-address
Minimum Access Level: Administrator
Command Mode: Config
Specifies the DHCP server to forward DHCP requests to.
Example:
dhcp relay address 132.23.4.2
dhcp relay max [
number
]
Minimum Access Level: Administrator
Command Mode: Config
Specifies the maximum number of DHCP clients.
Example:
dhcp relay max 133
number
– 1– 256. The default is 256. If a number is not specified, the number of clients is
reset to the default setting.