Paradyne 6371 - Manual (Page 103)

A. Command Line Interface
6300-A2-GB20-00 March 2002 A-31
show statistics [ eth1 | dsl1 | ip | bridge | pppoe | tftp ]
(Continued from previous page)
show statistics pppoe
The following statistics are displayed for show statistics pppoe :
PPPoE statistics:
Total Frames Received nnnn
Total Frames Transmitted nnnn
Discovery Timeouts nnnn
Total Frames Discarded nnnn
PPP statistics:
Total Frames Received nnnn
Total Frames Transmitted nnnn
LCP Frames Received nnnn
LCP Frames Transmitted nnnn
Authentication Frames Received nnnn
Authentication Frames Transmitted nnnn
NCP Frames Received nnnn
NCP Frames Transmitted nnnn
Total Frames Discarded nnnn
Refer to Table 5-6, Reasons for PPPoE Discarded Frames and Table 5-7, Reasons for
PPP Discarded Frames, in Chapter 5, Monitoring the DSL Router , for additional
information.
show statistics tftp
The following statistics are displayed for show statistics tftp :
TFTP statistics:
Packets Transmitted nnnn
Packets Received nnnn
Bytes Transmitted nnnn
Bytes Received nnnn
File Transfer Time (secs) nn
File Transfer Status Successful
show syslog
Minimum Access Level: Operator
Command Mode: Standard
Shows whether the current status of system as enabled or disabled. The severity level,
management IP address, and UDP port are displayed.
syslog {enabled | disabled}
level {emer | err | norm | info}
ip-addr x.x.x.x
domain {management | service}
port nnn
Table A-17. Show Commands (9 of 10)