Interface status, Performance statistics, Clearing statistics – Paradyne 6371 User Manual
Page 59
5. Monitoring the DSL Router
6300-A2-GB20-00
March 2002
5-3
Interface Status
Current status of the Ethernet (eth1) or DSL (dsl1) interface can be accessed
using the
show interface
CLI command.
Information provided about each interface includes the direction of the link, the
MAC address, Proxy ARP setting, the numbered interfaces, their IP addresses
and subnet masks.
See
show interface { eth1 | dsl1 }
Command Line Interface, for information about the command and what is
displayed when the command is entered.
NOTE:
The Primary designation of a numbered interface (e.g., eth1:1) marks that
interface as the one that uses its IP address as a Router ID. If no interface is
defined as Primary, the last numbered interface that was created becomes the
Primary IP Address.
Performance Statistics
Performance statistics are available for the DSL and Ethernet interfaces, for IP
processing, and for the bridge using the
show statistics
CLI command.
These statistics are above and beyond what is collected and reported at the
DSLAM.
See
show statistics [ eth1 | dsl1 | ip | bridge | pppoe | tftp]
Command Line Interface, for information about the
command and what is displayed when the command is entered.
Clearing Statistics
The CLI allows you to clear a set of statistics, resetting the counts to zero. Refer to
additional information.