Paradyne 6371 User Manual
Page 104
A. Command Line Interface
A-32
March
2002
6300-A2-GB20-00
show system
Minimum Access Level: Operator
Command Mode: Standard
Sample
show system
display:
March 23009:53:26 2001
System ID:
xxxxxxxx
Model #:
xxxx
, Serial #:
xxxxxxxxxxxx
, HW-Rev:
xxx
Boot: FW-Version
xxxxxxxx
2nd Stage Boot: FW-Version
xxxxxxxx
Image 0: FW-Version
xxxxxxxx
, [active]
Image 1: FW-Version
xxxxxxxx
DSP: FW-Version
xxx
Selftest Result: [0
xxxxx
] (if failed) {pass
|
fail}
show telnet
Minimum Access Level: Operator
Command Mode: Standard
Sample
show telnet
display:
Telnet - {enabled
|
disabled}
Telnet login - {enabled
|
disabled}
Telnet keep-alive - {enabled
|
disabled}
Telnet keep-alive interval:
xxxxxx
seconds
Telnet keep-alive timeout:
xxx
minutes
Telnet disconnect timeout:
xx
minutes
login ID access level
xxxx
{admin
|
operator}
show traps
Minimum Access Level: Operator
Command Mode: Standard
Sample
show traps
display:
warmstart {enabled
|
disabled}
authen fail {enabled
|
disabled}
selftest {enabled
|
disabled}
devfail {enabled
|
disabled}
test start {enabled
|
disabled}
test stop {enabled
|
disabled}
ccn {enabled
|
disabled}
link up {enabled
|
disabled}
link down {enabled
|
disabled}
For additional information, refer to
.
Table A-17. Show Commands (10 of 10)