Philips Xalio Vox - Manual (Page 26)

Your Xalio Vox answering machine 22
Switching on the answering machine by remote control
Before you can call into your answering machine by remote control, you need to
have entered a remote control code, see “Entering a remote control code” on
page 19.
Dial your telephone number.
Let it ring 9 times.
The answering machine will start up and send back a waiting tone.
Press
*
on the telephone and enter your remote control code.
Press 7 on the telephone keypad and hang up.
Your answering machine is once again ready to handle calls.
Calling into your answering machine by remote control
You can call into your answering machine from any telephone simply by calling
your own telephone number. You can use all the functions which are available
when you use your Xalio Vox handset (except for “Erase all messages” and fast
forward).
If your answering machine does not answer, the memory is full or the answering
machine is not switched on.
Dial your telephone number.
After the outgoing message, press
*
on the telephone.
Enter your 4 digit code.
Your answering machine will play back any messages automatically.
During the call you use the answering machine commands listed below. You
can also refer to the cut-out Memo card at the back of this manual.
If the code is wrong, the outgoing message will be repeated. After the
outgoing message has been replayed, try entering your code again. The
answering machine will hang up after 3 unsuccessful attempts.
Hang up to end the call.
The answering machine will return to the mode it was in before your call
unless you press 9 to switch off the answering machine. If it was on, it stays
on and is ready to handle calls.
Note:
If the Save function is on (see page 20) and messages are recorded on the
answering machine, the messages will be read after the 2nd ring . If there are no
messages recorded, hang up after the 3rd ring and you will not pay for the call as
the answering machine answers only after the 4th ring.
1
2
3
4
1
2
3
4