Pride Mobility Jazzy 1170XL - Manual (Page 38)

38 www.pridemobility.com Jazzy 1170XL
V I I . O P E R A T I O N
Battery Condition Meter
The battery condition meter is located in front of the joystick. This is a 10-segment illuminated display that
indicates that the Remote Plus is powered on and also gives the status of the battery, the controller, and the
power chair electrical system.
n Red, yellow, and green lights lit: Batteries charged; controller and electrical system OK.
n Red and yellow lights lit: Charge batteries if possible; controller and electrical system OK.
n Red lights only lit or slow flash: Charge batteries as soon as possible; controller and electrical system OK.
n Rapid flash of lights: Indicates a fault in the controller or the electrical system.
n Ripple up and down of lights: The joystick was not in the center position when the controller was
turned on. If you get “ripple up and down of lights,” turn off the controller, allow the joystick to return
to the neutral position, then turn on the controller.
NOTE: If you still get “ripple up and down of lights,” contact your authorized Pride Provider.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash,
reminding you the batteries need to be charged immediately!
Speed Settings
The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest
speed setting is 5. The settings are indicated by the number of lights that are lit.
NOTE: The speed settings are preset at the factory. If your authorized Pride Provider changes the order
of these settings, please make note of these changes. Contact your authorized Pride Provider for more
information.
To select a speed setting:
1. Press the on/off key to power on the remote.
2. Press the mode key once.
3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will in-
crease the speed setting.
4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the
speed setting.
5. Once you select the desired speed setting, press the mode key once to keep the setting or push the
joystick in the forward or reverse direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests,
you can operate them through the remote keypad. Contact your authorized Pride Provider for information
on how to operate these accessories.