Pride Mobility Jazzy 1170XL - Manual (Page 23)

Jazzy 1170XL www.pridemobility.com 23
V . C O M F O R T A D J U S T M E N T S
13. Reinstall the trapeze bars and secure with the
quick-release pins.
14. Reinstall the seat.
NOTE: Make sure the seat latch safety is flipped
down before using the power chair seat.
15. Plug the controller connector(s) into the electron-
ics tray.
Reclining Seat Adjustment
If your power chair is equipped with a reclining seat,
you can adjust the seatback recline with the seatback
release lever. The lever is located on the right side of
the seat base.
To adjust the reclining seat:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired
position.
3. Release the lever. Figure 18. Seatback and Armrest Adjustments
SEATBACK
ANGLE
ADJUSTMENT
SCREW
ARMREST KNOB
JAM NUTS
ARMREST
ANGLE
ADJUSTMENT
SCREW
Seatback Angle Adjustment
If your power chair is equipped with an angle adjustable seatback, you can adjust it to four (4) different
angles: 90°, 102°, 105°, or 107°. See figure 18.
To adjust the seatback angle:
1. Remove the seatback angle adjustment screws from both seat hinges.
2. Set the seatback at the desired angle.
3. Reinstall the screws to both seat hinges and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of each other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest receiver bracket. See figure 18.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.