Paradise P300 - Manual (Page 100)

P300H P300 Series Modem Installation and Operating Handbook Page 100
Remote M&C: 1:Protocol [Paradise]
2:Intfc [RS485] 3:Baud rate[2400] 4:Addr[123]
Change, Rem-M&C, Configure Menu
6.9.2 Change, Rem-M&C, CONFIGURE Menu
This menu configures the remote M&C port: The options are:
PROTOCOL This allows selection between OFF , PARADISE/FDC , and SA-bus . Full details of
the remote M&C protocols and messages is provided in the Remote M&C section
in Appendix D.
NOTE: Remote monitoring is possible with the selected protocol if the protocol
is not set to
OFF . Remote control is only possible if the protocol is not Off and
control has been selected as Remote on the Change, Remote M&C menu.
INTERFACE The options available here are RS232 or RS485. RS232 is only usable for a direct
connection between a single device and a PC. RS485 is required when more than
one slave device is connected to the remote M&C bus. Again see the Remote
M&C section for complete details of the electrical interface.
BAUD RATE The remote M&C Baud Rate is selectable, again see the Remote M&C section
for complete details of suitable Baud Rates for each protocol.
ADDRESS The bus address must be specified. The valid range for the Paradise / FDC
protocol is 1-255, for the SA-bus protocol the valid range of address is 49 to 111
(31H to 6FH).