Planet Technology VIP-2100 - Manual (Page 68)

VIP-2100 User ’s manual - 63 -
•
Primary Outbound Proxy Server: The IP address of an outbound Proxy
the SIP Stack uses.
•
Primary Outbound Proxy Port: The port of an outbound Proxy the SIP
Stack uses
•
Primary Outbound Proxy User: The User ID of an outbound Proxy the
SIP Stack uses.
•
Primary Outbound Proxy Password: The password of an outbound
Proxy the SIP Stack uses.
•
Secondary Outbound Proxy Server: The IP address of an outbound
Proxy the SIP Stack uses.
•
Secondary Outbound Proxy Port: The port of an outbound Proxy the
SIP Stack uses
•
Secondary Outbound Proxy User: The User ID of an outbound Proxy
the SIP Stack uses.
•
Secondary Outbound Proxy Password: The password of an outbound
Proxy the SIP Stack uses.
•
Codec Selection Policy: Selection order to match the remote SDP for
codec selection.
o
Local SDP Order: Use local SDP order to match codec
o Remote SDP Order: Use Remote SDP order to match codec
•
Local Codec 1~4: Codec selection priority (1 to 4) (1: highest, 4: lowest)
•
G.723 Bit Rate Used: G.723.1 high bits rate (6.3k) or low bit rate (5.3k)
is used
•
180 SDP: Set SDP for 180 ring message
•
183 SDP: Set SDP for 183 call progress indication.
•
DTMF Relay Method: DTMF transport type selection
o
Transparent: transmit DTMF over audio channel
o SIP INFO: Use SIP INFO Message to relay DTMF
o RFC2833: Use RFC2833 for DTMF over RTP packet
-
RFC2800 Payload Type: RTP payload type used for RFC2833
DTMF relay
•
Fax Transmission: Fax transparent type selection
o
T.38 Fax Relay: T.38 fax relay
o Transparent: Transparent mode (by voice packet)
•
Accept Proxy Call Only:
o
Yes: Only call from outbound proxy server is allowed
o NO: Accept any SIP calls
•
Inbound DM Group: Digit Manipulation Group for SIP incoming calls
•
Outbound DM Group: Digit Manipulation Group for SIP outgoing calls
Advance SIP Configuration:
Start Path: Configuration→SIP →Advance