Setup, Osd language, Pc mode adjust – Planar FULL-HD PD520 User Manual
Page 47: Caption, Prel imina ry
Planar PD520 Owner’s Operating Manual
35
PREL
IMINA
RY
Use the controls in the Setup menu to perform advanced image quality
adjustments and access various other PD520 features.
OSD Language: Select OSD Language from the Setup menu and press ENTER.
Then, use the up- or down-arrow buttons to select the OSD language (English,
French, Spanish, Portuguese or German). Press ENTER again to confirm your
selection.
PC Mode Adjust: To improve the quality of displayed images from a computer
or other VESA-compliant, RGB (480p or higher) source, select PC Mode Adjust
and press ENTER.
• Auto Adjust: Auto Adjust automatically adjusts settings to optimize computer
images. To execute Auto Adjust on command, select Auto Adjust and press
ENTER.
• Clock: Use the up- or down-arrow buttons ( , ) to highlight Clock. Then,
use the right-arrow button ( ) to increase the pixel clock rate; use the
left-arrow button ( ) to decrease it.
• Phase: Adjust the phase if the image shows shimmer or “horizontal noise.”
Pixel phase adjusts the phase of the pixel sampling clock relative to the
incoming signal. The effect of this control is similar to that of a tracking control
on a VCR.
For best results, use a good test pattern such as a smooth gray consisting of a
clear pattern of black and white pixels, or a similar “half on, half off” graphic
image. (You may notice that you can stabilize the image at more than one
point. Use either setting in this case.)
• H Position: Use the up- or down-arrow buttons ( , ) to highlight H Position.
Then, use the right-arrow button ( ) to shift the image to the right; use the
left-arrow button ( ) to shift the image to the left.
• V Position: Use the up- or down-arrow buttons ( , ) to highlight V Position.
Then, use the right-arrow button ( ) to shift the image up; use the left-arrow
button ( ) to shift the image down.
To restore the factory-default Clock, Phase and Position settings, select Factory
Reset and press ENTER.
Caption: Select Caption from the Setup menu to control the display of closed
captions when watching programs that contain them.
• Display: Select On or Off to control the display of closed captions.
• Mode: Select one of four captioning modes: CC1, CC2, CC3 or CC4. CC1
usually contains the native-language captions; if a program is captioned in
more than one language, those captions are carried on CC2, CC3 or CC4.
The PD520 also supports “text mode” captioning; to use this feature, select
Text1, Text2, Text3 or Text4. The text modes, instead of displaying a few lines of
captions somewhere on the picture, take over all or half of the screen to
display scrolling text information. (The text modes are seldom used today, so
most of the time there is no information there to see.) The text field is
sometimes used for embedding Internet data (called Interactive TV Links, or
ITV Links) in the captions.
Setup
Auto Adjust may take some time to complete, depending
on the characteristics of the incoming signal.
Note