Palm E2 - Manual (Page 25)

Tungsten™ E2 Handheld 4
CHAPTER 1 Setting Up Your Handheld and Your Computer
Step 1: Charging your handheld
0
1
Connect your handheld:
a. Plug the USB sync cable into
your handheld and into a USB
port on the back of your
computer.
b. Plug the AC charger into the
Multi-connector on your
handheld and into an outlet.
2
Charge your handheld for three hours. Be sure your handheld is fully charged
before going on to Step 2.
Done
Before You Begin [ ! ]
If you’re upgrading from
another Palm Powered™
device, synchronize your
old handheld with your
old desktop software.
Tip
On a laptop computer, the
USB port may be located
on the side.
Tip
After the initial charge,
charge your handheld at
least half an hour every
day.