Planet Technology WGS3-2840 - Manual (Page 76)

- 76 -
Figure A-1: Straight-Through and Crossover Cable
Please make sure your connected cables are with same pin assignment and color as above picture before deploying the
cables into your network.
A.3 Install the Mini-GBIC module
Please follow these steps to install the Mini-GBIC modules:
1. Power on the Layer 3 Managed Switch and place it on a flat surface. Install the new Mini-GBIC modules by inserting it
into the slots and sliding it in until it stops (See Figure A-2). Press it firmly until you feel the module snap into place. Never
force, twist or bend the Mini-GBIC modules. The Mini-GBIC module slides in smoothly and the Layer 3 Managed Switch
will automatically detect the new module.
Figure A-2: Insert the Mini-GBIC modules
2. After the fiber connection was built successfully. Check the LEDs to verify that if there is a link and a proper connection
at the port.
2081-A95020-000