Pioneer AS-LX70 - Manual (Page 31)

Surround sound settings 07
31
En
Dynamic Range Control
When watching Dolby Digital or DTS material at low
volume, low level sounds — including some of the dialog
— can be difficult to hear properly. Using one of the
Dynamic Range Control (DRC) settings can help by
bringing up the low level sounds, while controlling high
level peaks.
Dynamic Range Control works only with Dolby Digital
soundtracks and some DTS soundtracks.
1 Open the ‘Sound Setup’ menu.
2 Select ‘D.R.C.’, then press ENTER.
3 Select a setting.
Select one of the following:
• D.R.C. Auto – Only available for Dolby TrueHD
signals. Select D.R.C. High or D.R.C. Mid for signals
other than Dolby TrueHD.
• D.R.C. High – Dynamic range is reduced (loud
sounds are reduced in volume while quieter sounds
are increased)
• D.R.C. Mid – Mid setting
• D.R.C. Off – No dynamic range adjustment (use
when listening at higher volume)
4 Press to exit.
Dual mono setting
Specifies how dual mono encoded Dolby Digital
soundtracks should be played. You can also use this
setting to switch the audio channel on DVD-RW discs
recorded with bilingual audio.
1 Open the ‘Sound Setup’ menu.
2 Select ‘Dual Mono’, then press ENTER.
3 Select a setting.
Select one of the following:
• CH1 Mono – Only channel 1 is played
• CH2 Mono – Only channel 2 is played
• CH1/CH2 – Both channels are played through the
front speakers
4 Press to exit.
SETUP
ENTER
ENTER
ENTER
SETUP
ENTER
ENTER
ENTER
HTP-LX70_En.book 31 ページ ２００７年９月２８日 金曜日 午前１０時５１分