Listening to the radio, Improving poor fm reception, Improving poor am sound – Pioneer AS-LX70 User Manual
Page 28: Changing the noise cut mode, Listening to the radio 06, Chapter 6
Listening to the radio
06
28
En
Chapter 6
Listening to the radio
Important
•
To listen to the radio, press the
FM/AM
button
to set the remote control to FM/AM control mode. The
LCD screen on the remote control changes to the
FM/AM
screen.
Listening to the radio
The tuner can receive both FM and AM broadcasts, and
lets you memorize your favorite stations so you don’t have
to manually tune in every time you want to listen.
1
Switch to the tuner, then press repeatedly to
select the FM or AM band.
The display shows the band and frequency.
2
Tune to a frequency.
There are three tuning modes — manual, auto, and high-
speed:
•
Manual tuning
– Press
TUNE +/–
repeatedly to
change the displayed frequency.
•
Auto tuning
– Press and hold
TUNE +/–
until the
frequency display starts to move, then release. The
tuner will stop on the next station it finds. Repeat to
keep searching.
•
High-speed tuning
– Press and hold
TUNE +/–
until
the frequency display starts to move rapidly. Keep the
button held down until you reach the frequency you
want. If necessary, fine tune the frequency using the
manual tuning method.
Improving poor FM reception
If you’re listening to an FM station in stereo but the
reception is weak, you can improve the sound quality by
switching to mono.
1
Press after tuning to an FM radio station.
2
Select ‘Tuner Setup’ then press ENTER.
3
Choose ‘FM Auto/Mono’ then press
ENTER.
4
Select ’FM Mono’ then press ENTER.
The mono indicator (
) lights when the tuner is in mono
reception mode.
Select
FM Auto
above to switch back to auto-stereo
mode (the stereo indicator (
) lights when receiving a
stereo broadcast).
Improving poor AM sound
The simplest way to improve the sound quality of AM
radio is to make sure that the TV in the room is switched
off. Also try changing the position and direction of the
AM loop antenna.
Changing the noise cut mode
If you find that the AM sound quality is bad even after
trying the above, you may be able to improve it using a
different noise cut mode. Just choose the one that
sounds best.
1
Press after tuning to an AM radio station.
2
Select ‘Tuner Setup’ then press ENTER.
3
C
hoose ‘Noise Cut’ then press ENTER.
4
S
elect a Noise cut mode (1, 2 or 3) then
press ENTER.
FM/AM
FM/AM
1
2
3
FM/AM
-
+
TUNE
SETUP
ENTER
ENTER
ENTER
SETUP
ENTER
ENTER
ENTER
HTP-LX70_En.book 28 ページ ２００７年９月２８日 金曜日 午前１０時５１分