Pioneer Super Tuner III DVH-P7050 - Manual (Page 81)

Troubleshooting
Common problems
S ymptom Cause Remedy
Additional Information
En 81
English
Español
Deutsch
F
rançais
Italiano
Nederlands
12
Section
Power doesn’t switch ON.
The unit doesn’t operate.
Operation with the remote
control isn’t possible.
The unit does not operate
correctly even when the appropriate
remote control buttons are pressed.
Playback is not possible.
There’s no sound.
Leads and connectors are
incorrectly connected.
A fuse has blown.
Noise and other factors are
causing the built-in micro-
processor to operate incor-
rectly.
The remote control operation
mode is incorrect.
The remote control code is
incorrect.
Battery power is low.
Some operations are prohib-
ited with certain discs.
The disc is dirty.
The loaded disc is a type this
unit cannot play.
Non compatible video system
disc is loaded.
Connections are incorrect.
With some discs, 96 kHz out-
put is prohibited.
The unit is performing still,
slow motion or frame-by-frame
playback.
Confirm once more that all connections
are correct. (See page 90 – 97.)
Fix the problem causing the blown fuse,
and replace the old fuse with a new one
of the same capacity. (See page 90.)
Turn the unit off and then on.
Switch to the correct remote control
mode. (See page 12.)
Make sure the remote control code selec-
tion switch setting and code type setting
are the same. (See page 70.)
Load new batteries. (See page 16.)
Check using another disc.
Clean the disc. (See page 79.)
Check what type the disc is.
Change to a disc compatible to your
video system.
Check connections. (See page 90 – 97.)
Switch the output setting to
48 kHz. (See page 68.)
There is no sound during still, slow
motion or frame-by-frame playback.